TruSculpt 3D is an innovation RF (Radio Frequency) device that gives the skin-deep heat. Scottsdale, AZ board-certified plastic surgeon, Dr. Carlos Mata, a.k.a. Dr. Scottsdale® uses this to cause the fat cells to die thus creating non-invasive fat reduction, body sculpting/contouring treatment. In the process, it can temporally reduce the appearance of cellulite. It is designed to treat almost any area of the body. A sample of areas includes the abdomen, flanks, thighs, buttocks, arms and other stubborn regions where fat lingers. TruSculpt 3D is comfortable and requires no anesthetic. It is virtually pain-free. Most patients describe the treatment like a hot stone massage and others report almost no sensation of heat at all. This procedure has earned the name Lunchtime Skinny thanks to the short procedure time, about 15 minutes, and you can easily resume your normal daily activity after the treatment. Come and see us at your lunch break!
During a typical treatment, a small handpiece releases radiofrequency energy. This is placed over the targeted area and a small surrounding area. This energy cause fat cells to heat up and program them to liquefy and be removed through the lymphatic process after death. The energy released from the heat from the TruSculpt 3D also causes skin contraction for a slimming and smoothing effect on the skin. There is no downtime with this treatment, allowing you to return to your normal activity following treatment immediately. Patients will see significant improvement approximately 8 weeks following one TruSculpt 3D treatment and full results up to 3 months after. Additional sessions may be required to obtain desired results if more than usual results are expected.
After a brief pre-treatment preparation, the TruSculpt 3D handpiece is applied to the skin. The handpiece will deliver a pulse of RF (Radio Frequency) energy that will last 15 minutes on each treatment area. The handpiece will then be moved to the next treatment area to which this process will be repeated until the entire treatment area has been covered. The TruSculpt 3D System is designed to provide an easy and relaxed procedure for non-invasive fat removal and body sculpting/contouring. The small issues that can arise include redness, sweating and mild tenderness in the treated areas. This may last up to a full day depending on your skin type. Bruising in the treatment area does occur but rarely. Usually, most of the side effects resolve in an hour.
A unique advantage of the TruSculpt 3D is that it is well documented to help tighten lax skin because of the radiofrequency energy. RF has been used for many years as an energy source for tightening facial skin. Modifying how the energy is delivered by the TruSculpt 3D, lets the device decrease fat and tighten the skin at the same time.
The device releases radiofrequency energy that delivers controlled, yet comfortable doses of calming heat to the target zone, firming and smoothing problem areas over a 15-minute time frame.
Yes. TruSculpt 3D Body Sculpting and Skin Tightening is a NO DOWNTIME procedure giving you the freedom to return to your daily activities immediately post-treatment.
Typically a treatment in one area takes 15minutes and the lower abdomen and flanks take 1 hour.
|Procedure Recovery Location||Out-patient|